|
Re: Where to put the PCM???
Quote:
|
I have the same harnsss, trying to decide where to bring mine into the cab. Did you put any extra protection on the harness for heat from exhaust/trans?
|
I did not. I have the high hump and ran the main trunk of the harness at the top of the hump. It clears the trans by several inches so I don't think it will be impacted by the heat of the transmission. The wires to the starter and the O2's already have heat protection loom on them, so I think you should be good. If you are running the low hump you can pick up a 3" diameter by 3' long heat shield sleeve at O'Reilly's for $15.00 Might be cheap insurance.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021.
"I can't complain, but sometimes I still do. Life's been good to me so far."
|