Long story short, the truck was transported twice without wheels. The back brake backing plates are good, but the front ones on the 1962 c10 have a bent lip on the bottom.
I need to make it a roller and I can't put the brake drums (which have the wheel studs) with the bent backing plates.
All the rusty brake hardware is getting trashed. I see two bolts. Will removing those let me take the backing plate off or is it more involved? Can I even put the drum on without a backing plate?
Is removing the spindle in order to straighten the plates a better approach?
Where can I even buy a replacement backing plate if I end up cutting out the lip?
Anyone ever tried using a big hammer and straightening them out while still on the car?
Honestly, any advice and tips are appreciated it. I just need to get it rolling.
Full size images:
https://imgur.com/a/AvYuyrs