The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**WorkinLonghorn** · 03-10-2019, 10:52 PM

Did you check the float to see if it was full of gas? Did you pull the sender from the tank and see if it works manually moving the float arm?

Just assuming yours is similar to my '69. I can't remember my '63.

My '69 sits on empty every day since I bought it in '97 but eventually it will show the correct value, then go back to sleep. I never did figure this out. New sender, checked the wiring Etc.

03-10-2019, 10:52 PM	#7
WorkinLonghorn Senior Member Join Date: Dec 2006 Location: Studio City, Calif. Posts: 2,887	Re: Fuel gauge question #355 Did you check the float to see if it was full of gas? Did you pull the sender from the tank and see if it works manually moving the float arm? Just assuming yours is similar to my '69. I can't remember my '63. My '69 sits on empty every day since I bought it in '97 but eventually it will show the correct value, then go back to sleep. I never did figure this out. New sender, checked the wiring Etc. __________________ '69 GMC C2500 Custom Camper, 8 1/2' bed, New GM 350, NP 435 Close Ratio 4spd. Trans., 3.73 Dana-60 open.Camper and Trailer wiring, PS, PB, AC, tach , three gas tanks, stereo speakers, 2nd owner, Work-Truck supreme.