|
Go to a drive shaft specialist & they will fix this problem for you.
I have put a TH400 instead of a TH700R4 in a Burb , I took the front part of the two pieces driveshaft coming from the C-10 where the TH400 comes from , C-10 that I was parting out , let it lengthen and the sliding part of the front shaft will be fitted on the RR axle yoke...
I was a little frightened by my decision , but I saw that such drive shafts are installed on 4WD Blazers ( and I presume on 4WD Burbs & trucks either ) , without any problem
I did it that way because I didn't have a bracket to hold the two piece driveshaft on my Burb's frame
the Baron
__________________
1982 Suburban 2WD , 260ci Olds engine,TH400 , will get a 1979 front clip , might be ready in ... 2016
1985 Chevy Van ( 305/350 ) , "Kellogg" equipped , my actual D.D.
1960 Girl Friend , frame still good , body has some dents
|