The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Jack15T · 05-01-2019, 10:30 PM

The flat spot where the engine mount sits on the perch is almost worn through from the steel part of the engine mount. The rubber was compressed to the point that it was metal to metal contact. I'm not sure if these motor mounts are the correct ones for the perches. Also the hole in the middle is elongated. I'm not sure if there is a bushing that is supposed to go there as the through bolt from the engine mount is much smaller in diameter than the hole in the perch.

05-01-2019, 10:30 PM	#8
Jack15T Registered User Join Date: Jun 2018 Location: Sandy, Utah Posts: 102	Re: Motor Mount Perches? The flat spot where the engine mount sits on the perch is almost worn through from the steel part of the engine mount. The rubber was compressed to the point that it was metal to metal contact. I'm not sure if these motor mounts are the correct ones for the perches. Also the hole in the middle is elongated. I'm not sure if there is a bushing that is supposed to go there as the through bolt from the engine mount is much smaller in diameter than the hole in the perch.