[Driver_WT]

Originally Posted by mr48chev

This video is a bit long at 17 and some minutes but anyone installing a windshield in an AD should watch it for some pointers. https://www.youtube.com/watch?v=sAgklyxkW2Y They showed cutting the rubber on the old one but if you want to save the rubber you need to do the reverse (without the rope) of how they got the inner lip that goes over the pinch weld in. You have to roll it back out rather than in.
From past experience I'd use something to lube the rubber as you might end up tearing the rubber if you don't.

Watch the part where they pull the rope out at just past the 10 minute mark and you can figure out how you are going to have to roll that same rubber lip back on the other side of the pinch weld to get the rubber and glass back out. Lift, tuck, lift, tuck until you get most of it lifted and tucked on the other side so you can remove it.

Thanks for the info and video. My gasket is pretty good, so I think I will try to save it.

Wade