The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - The other guy 1967-72 c50 axle swap

Drewbee · 07-31-2019, 08:28 PM

No worries sweetk30. And diy4x makes some good stuff!

Thanks Pvmt Pndr!

That sounds close.

The rear is 40.5 center to center so a 1/4 inch on each side isn’t terrible. The front actually surprised me. If I’m reading it correctly the c60 frame is narrower than the k10 frames.

My Dana 60 is 32 centers and the c60 30 5/8.

Even if you could gain that extra 1 3/8 with custom spring hangers, I don’t know if there’s enough room on the passenger side of a Dana 60.

Hopefully I’m overthinking it.

07-31-2019, 08:28 PM	#11
Drewbee Registered User Join Date: Dec 2011 Location: Villa Rica, GA Posts: 330	Re: The other guy 1967-72 c50 axle swap No worries sweetk30. And diy4x makes some good stuff! Thanks Pvmt Pndr! That sounds close. The rear is 40.5 center to center so a 1/4 inch on each side isn’t terrible. The front actually surprised me. If I’m reading it correctly the c60 frame is narrower than the k10 frames. My Dana 60 is 32 centers and the c60 30 5/8. Even if you could gain that extra 1 3/8 with custom spring hangers, I don’t know if there’s enough room on the passenger side of a Dana 60. Hopefully I’m overthinking it.