The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

weedoublewide · 09-07-2019, 03:03 PM

I wanted to start her up today, but i remembered I had to finish installing the starter. Because I'm goofy and didn't install it while i had it out, like a normal person would've.

So as I was doing that I noticed that it doesn't fit flush with the bell-housing and the hole where the starter slides into is like 1/8" smaller. Does the hole need to be reemed out in order for it to sit flush?

09-07-2019, 03:03 PM	#1
weedoublewide Registered User Join Date: Apr 2016 Location: Rowlett, Tx Posts: 127	Gen1 Bellhousing with new style starter I wanted to start her up today, but i remembered I had to finish installing the starter. Because I'm goofy and didn't install it while i had it out, like a normal person would've. So as I was doing that I noticed that it doesn't fit flush with the bell-housing and the hole where the starter slides into is like 1/8" smaller. Does the hole need to be reemed out in order for it to sit flush?