WOW! Thank you so much, allow me to answer you one issue at a time.
Quote:
Originally Posted by dsraven
it looks like you were planning to bolt that to the underside of the frame, correct?
|
No, I layed it on top of the Camaro subframe, but I think I had the cross member backwards (pointy end to the rear of the truck) because that's how it had the best chance of being closest to the existing holes in the frame, yet this left it 3 inches too much forward in order to mate with the holes in the tail shaft.
I think the proper way to install this cross member is to have it point towards the front of the truck, but if I do that it is not wide enough so I will have to extend both sides, but even then there are no pre existing holes in the camaro subframe to accommodate it this way. I don't know jack about Camaros so I don't know if the late second gens even came with the TH400s. Oh well, I enjoy the learning process.
thanks again for all your words, I am still digesting the rest of them