The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

vince1 · 10-20-2019, 01:04 PM

I made one for an AMC 6 cyl. As I recall it was from a rectangle of 1 X 6 with plywood and a 4 X 4 on top and some strapping to hold it down. I drilled a hole through for a 1" bar that I have and with a 2 X 4 with shaved handle ends at the other end, 4 people can lift it quite easily.

10-20-2019, 01:04 PM	#2
vince1 Registered User Join Date: Jan 2013 Location: Calgary Alberta Posts: 1,170	Re: Engine cradle blueprint I made one for an AMC 6 cyl. As I recall it was from a rectangle of 1 X 6 with plywood and a 4 X 4 on top and some strapping to hold it down. I drilled a hole through for a 1" bar that I have and with a 2 X 4 with shaved handle ends at the other end, 4 people can lift it quite easily.