The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

wake328 · 10-23-2019, 03:49 PM

In the process of assembling my upper and lower control arm shafts. A couple of them, I struggled to even get the threads started into the arms much less have them perfectly centered.

So my question is... is there an accepted tolerance? Say .1-.2" off? Were you able to get yours perfectly centered? That seemed to be as close as I could get with most of them. I can see this affecting the caster angle.

10-23-2019, 03:49 PM	#1
wake328 Registered User Join Date: Apr 2017 Location: Minneapolis, MN Posts: 49	centering control arm shafts In the process of assembling my upper and lower control arm shafts. A couple of them, I struggled to even get the threads started into the arms much less have them perfectly centered. So my question is... is there an accepted tolerance? Say .1-.2" off? Were you able to get yours perfectly centered? That seemed to be as close as I could get with most of them. I can see this affecting the caster angle.