Then I wanted to get the carpet strips in place as well as the tailgate seal.
Everything looked good to me except the gap seems excessive between the tailgate and the seal with the gate closed...The gate seals well on the vertical side areas, but in the middle on the horizontal it's almost like the tailgate is bowed. See the below pic. Is this normal?
I addition I laid the rest of the dynamat that goes behind the rear panels and inside the doors then started to assemble the Retrosound radio unit so that I might be able to install it next time!
...the updated punch list:
PUNCH LIST
Under Dash
-Radio + Aux/USB in the cig lighter + hidden antenna
-Connect dash grounds
-Check carb gets to WOT with pedal travel
-Install glove box
Interior
-Install door seals (ordered new press on seals)
-Cut MLV and install under front carpet
-Finalize front carpet placement and make holes for shifter, dimmer switch, + seat bolts, seat belts
-Drill holes for: center console mounting holes and still plates
-Install tcase shifter, boot, + trim ring
Underhood
-Finish underhood wiring
-Install radiator overflow
-Install wiper fluid reservoir
-Install horns
-Cut 1/4" threaded rod for air cleaner stud
Misc
Get battery cables
Get fire extinguisher
Double check all fluids