The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

WunTon · 12-09-2019, 02:43 PM

Thanks for the info Captain. From my further searching it seems that most of the "universal" 60-66 versions are made to fit the 63-66 and need the mount hole drilled in a different place to fit the 60-62. I think I am going to try my luck with the 60-66 version from somewhere at half the cost and see how it goes. From what I have read none of them are a direct fit and will all need a bit of massaging anyway so we'll see how it goes! I need the floor pans, outer cab floor for the driver side and I am going to do inner and outer rockers as well since they have a small amount of rust starting so I figure if I am this far into it now may as well do it now rather than later.

12-09-2019, 02:43 PM	#3
WunTon Registered User Join Date: Sep 2019 Location: Purcellville, VA Posts: 102	Re: Patch panel ?'s Thanks for the info Captain. From my further searching it seems that most of the "universal" 60-66 versions are made to fit the 63-66 and need the mount hole drilled in a different place to fit the 60-62. I think I am going to try my luck with the 60-66 version from somewhere at half the cost and see how it goes. From what I have read none of them are a direct fit and will all need a bit of massaging anyway so we'll see how it goes! I need the floor pans, outer cab floor for the driver side and I am going to do inner and outer rockers as well since they have a small amount of rust starting so I figure if I am this far into it now may as well do it now rather than later.