The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - using a one piece driveshaft in a swb question

**1972BackInBlackC10** · 12-24-2019, 02:03 AM

Anyone here using a one piece driveshaft in a shortbox? what did you use? im looking for one I wont have to get cut down/

my set up is a 454 with a th400 (don't have the trans yet) lowered 4inch in the front and 5 in the back and I also have a CPP trailing arm crossmember installed with the larger driveshaft loop.

I have a one piece driveshaft I took out of a 69 swb that had a manual 3 speed on the column but not sure if it would be long enough, any help would be appreciated

12-24-2019, 02:03 AM	#1
1972BackInBlackC10 Senior Member Join Date: Jan 2012 Location: Estevan, Saskatchewan Posts: 1,025	using a one piece driveshaft in a swb question Anyone here using a one piece driveshaft in a shortbox? what did you use? im looking for one I wont have to get cut down/ my set up is a 454 with a th400 (don't have the trans yet) lowered 4inch in the front and 5 in the back and I also have a CPP trailing arm crossmember installed with the larger driveshaft loop. I have a one piece driveshaft I took out of a 69 swb that had a manual 3 speed on the column but not sure if it would be long enough, any help would be appreciated