Thread: wheels info
View Single Post
Old 12-29-2019, 04:30 PM   #1
bigmac73
Senior Member
 
bigmac73's Avatar
 
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
wheels info

Guys, for those of you who have upgraded to a 18 or 20 inch wheel, has any one had problems with the center hole fitting over the GM front brake rotor center hub or the rear axle hub??

I would like to use the following but I am leery of the measurements i have been getting
I am measuring around 3.085 to 3.088 on the rear center axle hub

https://www.summitracing.com/parts/are-50628006100
these state 3.080
what would be the right way to go? order these and do a skim cut on the ID of the center hole maybe 0.010 or take a die grinder and work the hubs a little and take them down a few thousands
__________________
Mike
72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider.
421 SBC / TH350 3000RPM Stall
Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks
bigmac73 is offline   Reply With Quote