[1Loud63PU]

Ok I took the cap off, and everything looks well inside.
The cap only goes on one right? It can’t spin over the distributor?

The cap had some spark markings on the contacts, but near the edge of each contact. Is that normal? You can almost see it in the photos, sorry I tried to get the best picture possible.

I had 2 vacuum hoses that were deteriorated so I replaced those, and it seemed to start a little bit faster, but not as fast as it should.

I also found a picture I took last year and reminded me of some springs that I didn’t install on the throttle cable.
1 photo is of both of the springs, 1 spring is cut in half for some reason.
The complete spring, I was able to see from the old photo where it was on the carburetor but the picture didn’t show where it was clipped into on the backside. I just clipped it into a bracket that seemed like it was suppose to hold the spring.
Here’s a split photo of where the spring is hooked on the carb, and onto a bracket on the manifold.
Do I have it in the correct spot?

Any idea where the second spring may have gone?

Thanks I’m advance.