[1Loud63PU]

Ok here’s what I have.
I have the 6 pin engine harness connector.
1 wire from that harness goes to the starter, terminal S.
Another wire from the connector goes to the starter terminal R.
Terminal R also has the distributor BAT wire connected to it.
Rest of the wires on the connector are for other oil/temp sensors.

That should be the correct wiring.

The distributor has a tach connector too, but I’m not using that right now, so I’ll leave it out of the mix.
The only plug on the distributor is the BAT wire that goes to the starter terminal R.
It also has mother connector that is connected within the distributor itself.

Here’s the connector I’m talking about on the distributor and the wire harness diagram. The diagram is for a V6 but everything else is the same.
Another member, Ray has also been helping with the wiring.