The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-55.1 Chassis table

slammed57 · 03-03-2020, 05:34 PM

If your going to roll it in and out of the shop the wood will flex a bit so it may through some measurements off. Mine was stationary, so once I trued everything up it stayed. Mr48 idea would work good. and if you can get the steel free then that will be the way to go. If your goin to run in the 8's holy crap what motor is goin in that thang! lol

03-03-2020, 05:34 PM	#9
slammed57 Registered User Join Date: Jan 2015 Location: pembroke pines, fl Posts: 711	Re: Chassis table If your going to roll it in and out of the shop the wood will flex a bit so it may through some measurements off. Mine was stationary, so once I trued everything up it stayed. Mr48 idea would work good. and if you can get the steel free then that will be the way to go. If your goin to run in the 8's holy crap what motor is goin in that thang! lol Last edited by slammed57; 03-03-2020 at 05:43 PM.