The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

SCOTI · 03-30-2020, 07:10 PM

Final upper template. Like stated previously, I was waiting to here from PB on obtaining some parts used on their C/O set-up but it seems w/the delays I'll just fab from what I have so far.

The lower bracket is pretty straight forward. You can see the template made (lower a-arm in white) that utilizes the bag mounting points as the centering of the final bracket. I'll need the upper in place to finalize the lower since the C/O will be slightly offset to clear the upper a-arm mounting hardware.

03-30-2020, 07:10 PM	#905
SCOTI Registered User Join Date: Apr 2001 Location: DALLAS,TX Posts: 21,931	Re: Project: Recycle Final upper template. Like stated previously, I was waiting to here from PB on obtaining some parts used on their C/O set-up but it seems w/the delays I'll just fab from what I have so far. The lower bracket is pretty straight forward. You can see the template made (lower a-arm in white) that utilizes the bag mounting points as the centering of the final bracket. I'll need the upper in place to finalize the lower since the C/O will be slightly offset to clear the upper a-arm mounting hardware. Attached Images __________________ 67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... *Cubic inches is like Indiana Jones with a cheap pistol.* Last edited by SCOTI; 03-30-2020 at 07:16 PM.