Quote:
Originally Posted by bubbasimms
I have rebuilt the 250 six for my truck project. Its never been started. It has already been sitting for almost a year and will probably be sitting for a few more as I finish the truck. It is basically a long block with the tins in place. I am slowly working on intake, exhaust, accessories and of course the rest of the truck. I keep it covered and I have oiled the inside well with assembly lube and engine oil. I wd40'd the bare parts of inside to prevent rust. It does have the clutch and trans attached to it.
Should I occasionally turn the motor over? Should I fill it with oil and prime the oil system occasionally? Should I install the starter and use the starter to turn it over while i spin the oil pump? Whats the best thing to do here?
|
Nice set up. I had the 4 Bbl Holley 8007, 390 CFM, on my 292 L6. My carb was 90* offset so the primaries opened over the plenums for both 1-2-3 and 4-5-6.
With your 2 Bbl configuration, you may be favoring 4-5-6, when you open the throttle. I had to saw off the lower part of the Holley throttle lever -- it's a kickdown for a Ford automatic, anyway, and I have a Chevy w/ SM465 -- that clears the intake. I solved linkage issues by finally going to a cable throttle from the accelerator pedal [GM '72-type] to an aftermarket cable to the carb.
I got 25 years out of the Holley. Then, after a rebuild of a 292, the carb wouldn't settle down. I replaced it with a 500 CFM Edelbrock 1404. Runs great now.
Some good advice about leaving the black moly assembly lube in place. I would put old spark plugs in the holes to keep them closed off and maybe blue 3M masking tape on the valve cover holes to keep dust and critters out. A ~1'' cork stopper would seal up the distributor hole.
Good luck on your build.