|
Re: Sway Bar / Lower Control Arm Compatibility
The end-link bushing set-up you linked is the same style that those DJM a-arms utilize but that doesn't mean their compatibility is a sure thing. I have 2 sway bars w/end links like that. Each bar is a slightly different width which would cause possible alignment issues if not used on a-arms w/the mount aligned.
If you cannot fabricate, I would verify what swap bar DJM recommends first. I you can fabricate, then @ worst you might need to relocated the a-arm mount placement on the a-arm so the link is plumb/vertical @ ride height.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|