Re: 69 K10 From the Field
Cleaned up the rear window bottom channel where there was a little surface pitting with a twisted wire wheel on the grinder. Then hit it for a Passover with the flap disc attached. Drilled four spots that looked like they were close to be a rust through spot to get to good metal. Welded everything up and just used a file to knock down the spot welds. Then laid down a small bead of Rage Extreme across the bottom channel. Knocked it down with a file and a long thin Durablock with 120 grit. Will be putting a layer of etching primer next.
While the back was setting up I grabbed a razor knife and started cutting around the seam of the windshield so it can removed and inspected. Once out the channel looked great only a little of surface rust in both of the top corner locations where the metal is sorta does an overlap and where it is seam sealed. Heated up the seam sealer with a little map gas on the torch and used a pick and flat blade screw driver to get it out.
|