The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-55.1 Installing door weather strip on '51 Chevrolet

Zippi · 05-08-2020, 10:08 AM

Only took about a month but my door seals came in later yesterday. This morning I cleaned the DS door and applied the larger "D" shaped seal on the door. I was hoping to shut the door and find no resistance as the smaller seal for the cab has not been applied yet. What I found was the door is very tight and will close if I slam it hard. I had to remove the little rubber door stop off the striker plate. Well.....at least the door did shut this time vs the SoftSeal door seals. I'm not sure why my doors are so tight. It has me baffled.

05-08-2020, 10:08 AM	#29
Zippi Registered User Join Date: Nov 2019 Location: Southern Indiana Posts: 585	Re: Installing door weather strip on '51 Chevrolet Only took about a month but my door seals came in later yesterday. This morning I cleaned the DS door and applied the larger "D" shaped seal on the door. I was hoping to shut the door and find no resistance as the smaller seal for the cab has not been applied yet. What I found was the door is very tight and will close if I slam it hard. I had to remove the little rubber door stop off the striker plate. Well.....at least the door did shut this time vs the SoftSeal door seals. I'm not sure why my doors are so tight. It has me baffled. Attached Images __________________ If you can't fix it with duct tape, it's an electrical problem. 1949 5 Window 3100 https://zippi6.wixsite.com/adtruck Last edited by Zippi; 05-08-2020 at 10:35 AM.