Quote:
Originally Posted by FAKKY
Few questions - dont want to spend $70 on parts to not fit ....
Q1)
The throttle body intake is 4". The Mass Air Flow Sensor is like 3.625" (pic below)
So that would mean I need a 4" silocne bend..... a 4" pipe ..... then an adapter from 4" to 3.6" on one side of the MAF and a a 4" to 3.5" (intake filter) adapter on other side of MAF. |
I had the same problem. I had some plastic that was between a 16th and an 8th thick and I cut a strip and wrapped it around and glued it to bring it up close to the 4" I needed.