Every aspect of the truck from here on out will be designed in Solidworks in my free time(which unfortunately theres not much of!)
I have a lot of preliminary models of components complete. The only design actually complete is the front suspension and crossmember design.
I spent months dialing in the suspension geometry based on my knowledge from the off-road world and a ton of reading i have done over the past couple years.
The final design ended up with 2 degrees of camber change and zero toe change throughout the suspensions travel.
I utilized off the shelf Joes Racing upper a-arms. they are very affordable units available in basically any length you may need and utilize k772 balljoints.
The lower arms utilize Rydman Ranch balljoint cups and Speedway bushings.
The steering rack is a Mustang II unit.