The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68 chevy truck-TPI · 07-03-2004, 06:18 PM

looks like a MAF setup. there is no hole in the back corner of the plenum were the MAP bracket mounts. if he can get the #'s off of the injectors the plenum and intake base i can tell you more about it. it also has the cold start injector that was not used on the MAP setup.

i took another look at it and it does not have a place for the EGR feed tube . and the fuel rail has the lines that turn out to the drivers side so it has to be an F-body setup off of a camaro or firebird/trans am. corvete lines turn down and to the passenger side. it is probally a 85-88 305 setup that intake base will bolt to old style heads without modification but the center holes will have to be modified if you want to use this on center bolt valve cover heads.

07-03-2004, 06:18 PM	#5
68 chevy truck-TPI A WORK IN PROGRESS Join Date: Apr 2004 Location: toccoa, georgia Posts: 205	looks like a MAF setup. there is no hole in the back corner of the plenum were the MAP bracket mounts. if he can get the #'s off of the injectors the plenum and intake base i can tell you more about it. it also has the cold start injector that was not used on the MAP setup. i took another look at it and it does not have a place for the EGR feed tube . and the fuel rail has the lines that turn out to the drivers side so it has to be an F-body setup off of a camaro or firebird/trans am. corvete lines turn down and to the passenger side. it is probally a 85-88 305 setup that intake base will bolt to old style heads without modification but the center holes will have to be modified if you want to use this on center bolt valve cover heads. Last edited by 68 chevy truck-TPI; 07-03-2004 at 07:01 PM.