Re: norms 55 chevy pu build
Another decent site is LS1tech.com. they have a classifieds section if you wanted to check pricing on some used stuff to get you going cheaper. On my 57 I used exh manifolds from an 01 camaro I think. They fit fine inside the frame and left room for steering linkage. I set my engine down low and rear ward. I did a firewall cut to get the engine far enough back so I would have room in front for an electric fan on the back side of the rad.Ill see if I can dig up some pics. My motor mounts were also camaro LS with urethane inserts. I connected the dots to the frame with some home built brackets. Again, pics pending.
|