The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

57taskforce · 12-14-2020, 06:23 PM

I think I would try and take it out as an assembly, do you have the drop Member/long knuckle setup? That’s what the 6” kit on my 1998 K2500 has. We had to do some welding to the frame on my truck when we put the lift on in 2004, been done long I don’t remember what it was we had to weld. If you could get it out as an assembly I would think it would go way faster.

12-14-2020, 06:23 PM	#2
57taskforce All about them K’s Join Date: Jun 2014 Location: Land of Entrapment Posts: 6,409	Re: Lift kit swap question. I think I would try and take it out as an assembly, do you have the drop Member/long knuckle setup? That’s what the 6” kit on my 1998 K2500 has. We had to do some welding to the frame on my truck when we put the lift on in 2004, been done long I don’t remember what it was we had to weld. If you could get it out as an assembly I would think it would go way faster. __________________ Tyler '57 3100 http://67-72chevytrucks.com/vboard/s...d.php?t=813888 '72 K20 Cheyenne: 5” lift, 35’s, front dana 60 blah blah blah… http://67-72chevytrucks.com/vboard/s...d.php?t=662879 ‘69 K10 SWB: 4” lift 33”s… in a million pieces http://67-72chevytrucks.com/vboard/s...d.php?t=805206 '98 Silverado LT K2500HD ECLB Vortec 454/4l80E: 6" lift 35x12.5x20’s Last edited by 57taskforce; 12-14-2020 at 06:42 PM.