[dream66]

Pics of 3-point Seat Belts from Brothers Truck parts on a 64.

The mounting instructions that came with the kit were hand drawn 2 dimensional and virtually useless.

Also, the kit was missing all of the mounting nuts.

The black lines are outlines of the sill plates when installed. I wanted to avoid seat belt bracket interference with the sill plates.

The passenger side worked pretty well although I did have to bend the angle bracket about 3 degrees.

The driver side bracket location was a challenge. The hole in the floor needed to be drilled about 3/8" forward of the floor brace to allow clearance for the nut and washer. Consequently the belt recoil mechanism had to be located about 1 1/2" forward of ideal.