The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

edgeleycanuck · 01-01-2021, 07:29 PM

I used the lokar linkage to connect that transmission to a late seventies earlier eighties gm tilt column in an AD truck. Quite satisfied with it. I used a peice of steel rod versus the stainless that comes with, as a sacrificial mockup. You have to get the right length of rod and locate the trans end in a spot that gives you full travel in order to get everything from.park to 1st. Lokars instructions suggest a good starting point.

01-01-2021, 07:29 PM	#2
edgeleycanuck Registered User Join Date: Jan 2014 Location: edgeley sask Posts: 93	Re: Lokar shift linkage I used the lokar linkage to connect that transmission to a late seventies earlier eighties gm tilt column in an AD truck. Quite satisfied with it. I used a peice of steel rod versus the stainless that comes with, as a sacrificial mockup. You have to get the right length of rod and locate the trans end in a spot that gives you full travel in order to get everything from.park to 1st. Lokars instructions suggest a good starting point.