The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Wiper Motor Install (Grommets, Seals, Timing Marks)

Rich72C10 · 01-02-2021, 03:59 PM

as I feared none of GMCPaul's grommets came with a grounding stinger. Very disappointing - since if I had not stumbled on the threads here about the Wiper Motor grounding I would have installed these non-the wiser.

Though now I need to figure out how to remove that one grommet and then re-design a ground between the motor and something in the dash.

I have to say, between my Tach upgrade (lens/speedo tin issue) and these grommets that I got from GMCPaul's, I am getting a bit frustrated with their parts :'(

01-02-2021, 03:59 PM	#9
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,687	Re: Wiper Motor Install (Grommets, Seals, Timing Marks) as I feared none of GMCPaul's grommets came with a grounding stinger. Very disappointing - since if I had not stumbled on the threads here about the Wiper Motor grounding I would have installed these non-the wiser. Though now I need to figure out how to remove that one grommet and then re-design a ground between the motor and something in the dash. I have to say, between my Tach upgrade (lens/speedo tin issue) and these grommets that I got from GMCPaul's, I am getting a bit frustrated with their parts :'( Attached Images __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| *Upgraded Fully Super Trim