The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

SCOTI · 02-24-2021, 10:09 AM

I would try big tube SBC headers for a front steer car (Chevelle/2nd GEN f-body). The car headers seem to fit decently on a truck & don't hang as far below like typical truck spec units.

Beyond that, there's always buying truck spec headers & cutting them up to make them fit how you need so they don't hang as low or do one of the 'DIY' header kits where you piece what you want together & then have them welded up.

02-24-2021, 10:09 AM	#2
SCOTI Registered User Join Date: Apr 2001 Location: DALLAS,TX Posts: 22,132	Re: Headers for big inch SBC I would try big tube SBC headers for a front steer car (Chevelle/2nd GEN f-body). The car headers seem to fit decently on a truck & don't hang as far below like typical truck spec units. Beyond that, there's always buying truck spec headers & cutting them up to make them fit how you need so they don't hang as low or do one of the 'DIY' header kits where you piece what you want together & then have them welded up. __________________ 67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... *Cubic inches is like Indiana Jones with a cheap pistol.*