|
Re: 67-72 Engine Perches into 62 C10 - L & R ?
I'm pretty sure I have the brackets oriented correctly with the nubs pointing back, but have a difference between left and right gaps to the frame. The left is about a full inch above the frame and the right is only 1/4". Should I shim the brackets snug to the frame and forget the difference side to side? The engine is sitting level side to side and has about 3.5 degrees angle front to rear. The rear of engine is resting on the original manual trans cross member and the front is resting on the engine brackets. It it common for the brackets to need different size shims on left and right? Hoping my frame isn't tweaked, maybe my brackets are off? Any help is appreciated
Bob
|