HP Tuners Tutorials - Part IX - Enable Power Enrichment aka Accelerator Pump
Part IX - Enable Power Enrichment aka Accelerator Pump / Secondaries
We find the Power Enrichment settings in two places in the VCM Editor. The first place is under Engine \ Fuel \ Power Enrich tab and then the Delay section
Here we see how a Tahoe engine was configured:
RPM 5,000
Delay 0.8
This basically means do not kick in Power Enrichment unless this Soccer Mom holds the RPM at or above 5,000 for more than .8 seconds, (basically that will never happen) so essentially PE is disabled on this SUV
Note: your default factory settings may vary slightly, the RPM may be 5,500 and the Delay may actually already be 0
Last edited by Gregski; 03-19-2021 at 06:50 PM.
|