The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**cwcarpenter98** · 03-28-2021, 09:18 PM

Was underneath my truck yesterday and noticed that the clutch linkage rod is about half way worn through. I did see the replacement that's available online, but I'm not sure of the quality of it.

I need the rod that goes from the clutch pedal to the z-bar. I think I probably also need a z-bar as the hole has gone egg shaped from wear. (Edit to add: Now that I look again at the pictures, maybe I don't need the z-bar.)
Was there some sort of bushing from the factory that was supposed to be there?

On the door latch stuff, I need the latch and striker for the passenger side. Both are heavily worn and I can't get the passenger door to close good at all.

I could also use a passenger window regulator in good condition, but that would be kinda costly to ship, so I might just try rebuilding the one I have.

Any input is welcome here

03-28-2021, 09:18 PM	#1
cwcarpenter98 Senior Member Join Date: Jan 2018 Location: Hickory Flat, GA Posts: 4,508	WTB Clutch Linkage & Door Latch Parts Was underneath my truck yesterday and noticed that the clutch linkage rod is about half way worn through. I did see the replacement that's available online, but I'm not sure of the quality of it. I need the rod that goes from the clutch pedal to the z-bar. I think I probably also need a z-bar as the hole has gone egg shaped from wear. (Edit to add: Now that I look again at the pictures, maybe I don't need the z-bar.) Was there some sort of bushing from the factory that was supposed to be there? On the door latch stuff, I need the latch and striker for the passenger side. Both are heavily worn and I can't get the passenger door to close good at all. I could also use a passenger window regulator in good condition, but that would be kinda costly to ship, so I might just try rebuilding the one I have. Any input is welcome here Attached Images __________________ Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson Last edited by cwcarpenter98; 03-28-2021 at 09:23 PM.