[miket]

Bobby--thanks for the reply---It might have confused me a little but I think I have narrowed down all the wires. The first thing that confused me in your reply was ditching the external VR harness but retainin the blue and white wires...well the blue and white ones come only from E-VR plug...so I don't see how you can do that---however the brown wire is switched 12 volt...so I figured I would use it to feed term "L" on the alt VR plug. The other two wires on the E-VR is a large red for power (was one of four soldered together) and the brown one which seemed to have fed it 12 volts. I have since removed this entire plug assy. I think other than that I am set for now...since I am running out of time and need the truck at least running, I am going to stick with the original red charge wires that run from the alt--then "T" off---going to the original dist block by the battery and then to the fuse block under the dash...the two ammeter wires and fuses, I am leaving those there until I get bigger feed wires. Now that I read this---its sounds like a two wire...which doesn't sound right....I have the brown wire going to term "L" for turn on---I have the main feed going to the charging stud....what am I missing? Also I have gauges----