The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

crazy longhorn · 07-15-2004, 08:53 PM

I think you done good ! A few yrs back, Im guessin about 15yrs....I went freakin roundy pounders with the wifey over an Ls6 crate! The tough part is that I could have had d@mn near had 2 Ls6 crates for what that BB Olds cost! they were about $2650 per at the time. when you build er up, you might think about dropping the comp ratio into pump gas levels, if you plan street use.....on the strip, go for it! that was a 450-460 hp mill! best of luck,crazyL

07-15-2004, 08:53 PM	#2
crazy longhorn Fabricate till you "puke" Join Date: Jun 2002 Location: Ill Posts: 9,402	I think you done good ! A few yrs back, Im guessin about 15yrs....I went freakin roundy pounders with the wifey over an Ls6 crate! The tough part is that I could have had d@mn near had 2 Ls6 crates for what that BB Olds cost! they were about $2650 per at the time. when you build er up, you might think about dropping the comp ratio into pump gas levels, if you plan street use.....on the strip, go for it! that was a 450-460 hp mill! best of luck,crazyL __________________ 69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....