Re: Time for a Canadian build thread
Little bit of progress in the last few days
Cut the top of the horse collar cross member for driveshaft clearance. Still need to get a driveshaft made but I'm thinking I should make some custom engine mounts and move the engine back as far as I can.
And started looking at the steering. The pitman arm is too close to the lower A arm and the front bolt of the steering box doesn't have anywhere to go because of the Z notch. And of course the steering shaft wants to go through the upper A arm. Going to be a bit of head scratching going on here. I could ad a tab for the front bolt on the steering box but I don't actually have the rad I'm going to use so I'm not sure if there is going to be radiator/steering box interference.
Last edited by static80; 12-01-2021 at 02:31 AM.
|