|
Re: Gear setup
That's more like it. The pattern seems a bit "bigger" than most, but that could simply be how much compound was applied. Look at the teeth further around, where the compound is rubbed back onto the gear too. That can tell you something too. Also, some of the look of the pattern is based upon how the manufacturer intends them to look. They can very a bit.
Make sure that you properly break it in with a few short heat-cycles. The lower the ratio, the more important this is, but don't neglect it.
__________________
You can review the site's rules here.
Quote:
Originally Posted by Longhorn Man
As for reading directions...
The directions are nothing but another man's opinion.
|
Learn from the mistakes of others, you won't live long enough to make them all yourself...
Bad planning on your part does not necessarily constitute an instant emergency on my part....
The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|