The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

The Joker · 07-24-2004, 09:32 PM

I am trying to convert one sub with a tail gate to barn doors. Most of the holes and indentations are there for the doors, except the striker plate on top in the middle that holds the drivers side back barn door shut. So I am going to have to cut one out of another sub and weld it in. It is shown in the first picture of sub4rvr. I couldn't find the other post about the doors either.

07-24-2004, 09:32 PM	#6
The Joker Registered User Join Date: Dec 2002 Location: north cheyenne Posts: 30	gate I am trying to convert one sub with a tail gate to barn doors. Most of the holes and indentations are there for the doors, except the striker plate on top in the middle that holds the drivers side back barn door shut. So I am going to have to cut one out of another sub and weld it in. It is shown in the first picture of sub4rvr. I couldn't find the other post about the doors either. __________________ The Joker Last edited by The Joker; 07-24-2004 at 09:39 PM.