|
Re: Clutch help
If you can get an adapter fitting for the T56 slave (T.O. bearing) to connect to the NV3500 MC but IDK if the stroke/volume of the NV3500 MC is enough or too much for the T56 slave
IIRC the input shaft for the T56 is 26 spline
McLeod offers MC for several applications so that might be a source. They use Wilwood compact MC and make the adapter for several applications
Your donor T56 will have a slave/TO that goes over the input shaft. A few sizes so you need to get the right one and then measure your clutch stack height and add shims if needed to get the correct gap between clutch PP diaphragm, and TO bearing
Ideally someone who has done a T56 swap can give specific part #'s
|