I've been working on this truck on and off for almost two years now.
- The reverse light switch is back in its home and adjusted.
- Replaced the wiper motor and retrofitted to the electric washer pump tank.
- Reconnected the 4x4 light wires although it seems that I will need to
- check the switch in the np208 because its not turning on.
- Installed an RV license plate holder with built in light.
- Replaced fuel filter.
- Cleaned all the electrical connections on the firewall. Gas gauge started working!
- Newer batteries.
- Replaced the starter solenoid.
- Replaced the rear axle shaft seals and brake shoe that was soaked in gear oil.
- Changed all locks and ignition keyed to something other than the standard CUCV key.
- Lubed the window crank workings.
- Installed new rear window crank and tailgate latch.
- Fixed the horn by installing the fuse for it. (go figure!)
- Replaced the center link to fix the sloppy steering.