The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**pjmoreland** · 11-14-2022, 03:12 AM

Here are some photos of an OE 67/68 adjuster rod on a bench seat I had in my truck. Both ends had a double 90° bend. There was a hole at the rear of the bottom frame for a support spring. I didn't have the original spring so I found one at Ace that worked.

11-14-2022, 03:12 AM	#6
pjmoreland Senior Member Join Date: Jan 2005 Location: CA Posts: 6,248	Re: Bench seat adjusting rod question Here are some photos of an OE 67/68 adjuster rod on a bench seat I had in my truck. Both ends had a double 90° bend. There was a hole at the rear of the bottom frame for a support spring. I didn't have the original spring so I found one at Ace that worked. Attached Images Last edited by pjmoreland; 11-14-2022 at 07:24 PM.