The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Trailing arm crossmember with No Limit Arms

**Accelo** · 02-01-2023, 01:43 PM

Some great ideas. I admit you have to be stubborn just to do the hole saw thing. Cutting the section out with a torch is easiest. With out a torch adding the holes around the perimeter is a great idea. Wish I would have thought of that. If you do use a hole saw getting it to run slow it your best bet. You will ruin the hole saw if you don't. Then there is the safety aspect, a drill large enough to g slow is a hazard to life and limb if you don't have a plan to deal with the torque. Back to the torch if you have one.
Cheers.

02-01-2023, 01:43 PM	#21
Accelo Senior Member Join Date: Mar 2015 Location: washington Posts: 2,198	Re: Trailing arm crossmember with No Limit Arms Some great ideas. I admit you have to be stubborn just to do the hole saw thing. Cutting the section out with a torch is easiest. With out a torch adding the holes around the perimeter is a great idea. Wish I would have thought of that. If you do use a hole saw getting it to run slow it your best bet. You will ruin the hole saw if you don't. Then there is the safety aspect, a drill large enough to g slow is a hazard to life and limb if you don't have a plan to deal with the torque. Back to the torch if you have one. Cheers.