Started getting a lot of the internal bits cleaned up yesterday just to make less of a mess while reassembling. At the rate I’m going, maybe I’ll get this back together by next year
Edited on 3/31/23 to add:
Started a smidge of reassembly after dinner. A 1.25” pvc pipe works great to gently persuade the new input shaft bearing on with a little help from the Tonya Harding 3000.
Also got the tail shaft bushing installed with a little bit of help from the slip yoke. Didn’t damage the bushing and the yoke spins freely
__________________
Christian Carpenter
1963 C10 -
Frankentruck 283, Muncie 3 speed with overdrive
Overdrive wiring here
1963-ish truck bed trailer -
Half-Wit
1981 C10 -
Penny 305, th350 --> Soon to be 350, Saginaw 4 speed
1995 Dodge Dakota Sport
"I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson