Quote:
Originally Posted by Dodge68charger
I Have An American Autowire Harness With a Pink and green Wire and 2 purple wires
Posted via Mobile Device
|
If your wire harness has the same electrical connector’s as the factory truck wire harness you can make the van neutral safety switch work without changing your connector’s. By the two connector’s for the Starter to engage ( yellow & purple wires on the factory harness ) there is a plastic tab sticking up by one of the connector’s, take a good pair of needle nose pliers & wiggle it back & forth to break it off. Next go the two connector’s at the bottom of the neutral safety switch, those are your backup lights wires, you want take your needle nose pliers & give both of the connector’s a little twist so they make a angle to fit the wire connector. Use your wire connector as as a guide to make your adjustment to the terminals on the neutral safety switch. You will also need to move your neutral switch down your column around 7” for the van column to work in your truck. ( see pictures ) The column on the left is a factory truck tilt column & the right is a van column.
Posted via Mobile Device