The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Rebuilding / Installing Hinge Pillar to Fender Seal

Rich72C10 · 08-14-2023, 03:53 PM

Ran out of photo attachments, I had one more.

Edit: Also it may be that when a truck has these you will also have Under Cowl Seals / Cowl End Seals

https://gmcpauls.com/rubber&ws1.htm
"1967-72 Truck, Blazer, Jimmy, Suburban, Panel Correct style & fitting hood to cowl foam end seals, these install on either end of the hood to cowl seal under cowl edge sealing entire cowl to cab area not covered by hood to cowl seal. Includes 2, 1 each for left and right side."

08-14-2023, 03:53 PM	#2
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,687	Re: Rebuilding / Installing Hinge Pillar to Fender Seal Ran out of photo attachments, I had one more. Edit: Also it may be that when a truck has these you will also have Under Cowl Seals / Cowl End Seals https://gmcpauls.com/rubber&ws1.htm "1967-72 Truck, Blazer, Jimmy, Suburban, Panel Correct style & fitting hood to cowl foam end seals, these install on either end of the hood to cowl seal under cowl edge sealing entire cowl to cab area not covered by hood to cowl seal. Includes 2, 1 each for left and right side." Attached Images __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| Upgraded Fully Super Trim Last edited by Rich72C10; 08-21-2023 at 09:09 AM.*