|
Re: Rebuilding / Installing Hinge Pillar to Fender Seal
I am going to say this is a 5/16 Hex Lipped/Washer #10x1/2 Black Oxide Sheet Metal screw.
I finally found my bolt/screw gauge and my one original screw fits the #10 hole.
Loved to see what you come up for confirmation.
If so, I think I'll buy some of these off Amazon:
Small Parts 1008ABW188B 18-8 Stainless Steel Sheet Metal Screw, Black Oxide Finish, Hex Washer Head, Hex Drive, Type AB, #10-16 Thread Size, 1/2" Length (Pack of 25)
__________________
Richard
'72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT
SBC 350 | TH350 | LWB | AC | Buddy Seats
Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock
Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim
Last edited by Rich72C10; 08-15-2023 at 10:22 AM.
|