The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Rebuilding / Installing Hinge Pillar to Fender Seal

Rich72C10 · 08-16-2023, 10:03 AM

I think I might have a problem? I was spying inside the fender / inner cowl crack when my door open and I think there is a lip on the inner cowl. I don't think that should be there - since the bracket won't be able to wrap around?

Thoughts? You should be able to see the lip I am talking about in my photo and I know from the PO about ~15 years ago the truck was "restored". I'm screwed - right?

08-16-2023, 10:03 AM	#12
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,687	Re: Rebuilding / Installing Hinge Pillar to Fender Seal I think I might have a problem? I was spying inside the fender / inner cowl crack when my door open and I think there is a lip on the inner cowl. I don't think that should be there - since the bracket won't be able to wrap around? Thoughts? You should be able to see the lip I am talking about in my photo and I know from the PO about ~15 years ago the truck was "restored". I'm screwed - right? Attached Images __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| *Upgraded Fully Super Trim