The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 55.2-59 Loose signal light housing on column

**Andy_Napco** · 09-08-2023, 12:26 AM

Northern,

I had the same issue, I cut a piece of thin sheet metal to fit between the column and wedge as a shim. You could probably trim a piece of a hose clamp too, gives the needed curvature. It’s been easy to snug up, I used an Allen head bolt in place of the original, much easier to tighten!

Andy

09-08-2023, 12:26 AM	#2
Andy_Napco Junior Member Join Date: Apr 2011 Location: Benicia, California Posts: 40	Re: Loose signal light housing on column Northern, I had the same issue, I cut a piece of thin sheet metal to fit between the column and wedge as a shim. You could probably trim a piece of a hose clamp too, gives the needed curvature. It’s been easy to snug up, I used an Allen head bolt in place of the original, much easier to tighten! Andy